Printer Status LED’s The Epic 880TM printer has four indicator lights to indicate various operating states of the printer. In general these are Fault, Cover Open, Paper Status, and Ready. The printer may be in normal operation, self test or in one of two boot load...
The Diagnostics/Config button The printer has a configuration and diagnostics button on the right side of the printer, labeled CONFIG. The Diagnostics/Config button is a multifunction button. By pressing and releasing the Diagnostics/Config button, the printer will...
Communications Interface RS232 Serial Communications Interface The RS232 Serial interface connector is a 14 position Molex Minifit Jr®., part number 39-30-1140, which mates with Molex part number 39-01-2140 or equivalent. Signal Voltage and Current levels The serial...
Configuration There are two ways to configure the Epic 880TM printer: the first is to use the manual configuration sequence by using the CONFIG and FEED key, and the second is to use TransAct’s remote configuration software. TransAct Technologies offers the use of a...
USB and RS-232 communications are supplied through interface connections at the rear of the printer, as illustrated in the figure. The Serial RS-232 interface connector is a locking Molex connector and the USB interface is a standard USB B connector. Power is supplied...
