Epic 880 Support Topics
The Diagnostics/Config button The printer has a configuration and diagnostics button on the right side of the printer, labeled CONFIG. The Diagnostics/Config button is a multifunction button. By pressing and releasing the Diagnostics/Config button, the printer will...
Epic 880 Support Topics
Communications Interface RS232 Serial Communications Interface The RS232 Serial interface connector is a 14 position Molex Minifit Jr®., part number 39-30-1140, which mates with Molex part number 39-01-2140 or equivalent. Signal Voltage and Current levels The serial...
Epic 880 Support Topics
Configuration There are two ways to configure the Epic 880TM printer: the first is to use the manual configuration sequence by using the CONFIG and FEED key, and the second is to use TransAct’s remote configuration software. TransAct Technologies offers the use of a...
Epic 880 Support Topics
USB and RS-232 communications are supplied through interface connections at the rear of the printer, as illustrated in the figure. The Serial RS-232 interface connector is a locking Molex connector and the USB interface is a standard USB B connector. Power is supplied...
Epic 880 Support Topics
The correct printer driver depends on what Operating System you are using. You can find the drivers here
Epic 880 Support Topics
Verify the Epic 430 printer has power and is connected to the system or game. This printer is a thermal printer that requires thermal paper. Make sure the paper is loaded properly. See diagram below: Loading Paper The Epic 880 printer uses a continuous roll of POS or...
